MATERIAL SAFETY DATA SHEET 2018
PRODUCT AND COMPANY IDENTIFICATION
1.COMPOSITION / INFORMATION ON THE INGREDIENTS
CHEMICAL NATURE OF THE PRODUCT: Inorganic thixotropic,
materials with gums,
& ground rubber
HAZARDOUS COMPONENTS IN PRODUCT: None
1.IDENTIFICATION
MAIN HAZARDS: Not classified as dangerous
HEALTH EFFECTS: Eyes – May cause irritation – Avoid contact
HEALTH EFFECTS: Skin – May cause irritation – Avoid contact
HEALTH EFFECTS: Ingestion – May be irritant in contact with digestive
tract – Do not swallow
HEALTH EFFECTS: Inhalation – Could cause drowning if inhaled but
unlikely due to viscosity
4) FIRST AID MEASURES
FIRST AID – EYES: Immediately flood the eye with plenty of
water for at least 5 minutes holding the eye
open
FIRST AID – SKIN: Wash skin with plenty of water
FIRSTY AID – INGESTION: Drink lots of water – seek medical attention
ADVICE TO PHYSICIANS: Treat symptomatically
5) FIRE FIGHTING MEASURES
EXTINGUISHING MEDIA: None, product is non-flammable liquid
FIRE OR EXPLOSION HAZARDS: None
MEANS OF PROTECTION: None necessary
OTHER RECOMMENDATIONS: None
6) ACCIDENTAL RELEASE MEASURES
PRECAUTIONS FOR INDIVIDUAL: Wear gloves and protective glasses
PRECATIONS FOR ENVIRONMENT: Prevent material from entering drains or watercourses. Advise authorities if spillage has entered watercourse or sewer, or has contaminated soil or vegetation.
CLEANING PROCEDURES: Sweep up into suitable containers for disposal.
7) HANDLING AND STORAGE
HANDLING – SPECIFIC PRECAUTIONS: None
HANDLING – INCOMPATIBILITY: None
STORAGE – SPECIFIC PRECAUTIONS: None – (Store in dry area)
STORAGE – INCOMPATIBILITY: None
8) EXPOSURE CONTROL /
PERSONAL PROTECTION
UK OCCUPATIONAL EXPOSURE STANDARDS: None assigned
PROTECTIVE EQUIPMENT: Use of the basic principles of industrial hygiene will enable this material to be used safely. Wear protective gloves and chemical goggles.
9) CHEMICAL AND PHYSICAL PROPERTIES
PHYSICAL STATE: Thixotropic liquid
COLOUR: Green with black rubber particles
PH: Approximately 9.5
BOILING POINT: Data not available
DECOMPOSITION POINT: Data not available
FLASH POINT: Data not available
EXPLOSION LIMITS: Data not available
DENSITY: Approximately 1,05
AUTO – FLAMMABILITY: Data not available
10) STABILITY AND REACTIVITY
STABILITY: Stable in normal conditions
DANGEROUS REACTIONS: None known
MATERIALS TO AVOID: None known
HAZARDOUS DECOMPOSITION PRODUCTS: None known
11) TOXICOLOGICAL INFORMATION
ACUTE TOXICITY: No relevant studies identified
IRRITANCY – EYES: No relevant studies identified
CHRONIC TOXICITY/CARCINOGENICITY: No evidence of effects
GENOTOXITICY: No relevant studies identified
REPRODUCTIVE/DEVELOPMENT TOXICITY: No relevant studies identified
12) ECOLOGICAL INFORMATION
MOBILITY: The product will dissolve slowly in water
DEGRADABILITY: The product is expected to be readily biodegradable
BIO – ACCUMULATION: Not expected to bio-accumulate
ECOTOXITICY: No relevant studies identified
13) DISPOSAL
Small quantities should be diluted with large amounts of water and run to waste.
Large quantities should be disposed of by landfill – Dispose in accordance with local and national regulations using an approved disposal company.
14) DISPOSAL INFORMATION
UK TRANSPORT INFORMATION: Not Classified
UN CLASS: Not Classified
ADR / RDI CLASS: Not Classified
IMDG: Not Classified
IATA: Not Classified
15) REGULATORY INFORMATION:
LABELING INFORMATION
HEALTH: Not Classified (H)
PHYSIO – CHEMICAL PROPERTIES: Not Classified (S)
ENVIRONMENT: Not Classified (E)
16) OTHER INFORMATION
UK LEGISLATION:
* Health and Safety at Work Act Etc. 1974 and Relevant Statutory Provisions.
* Management of Health and Safety at Work Regulations, 1992.
* COSSH Regulations 1988.
* Chemicals (Hazard Information and Packaging) Regulations 1993
MSDS DATA REVISED: 31st October 2018
NOTICE:
Information contained in this publication while accurate to the best knowledge and belief of Lameduck Enterprises is not intended and should not be construed as a warranty of representation for which Lameduck Enterprises assumes any legal responsibility.
Any information or advice obtained from Lameduck Enterprises otherwise than by means of this publication and whether relating to Lameduck Enterprises materials or other materials is also given in good faith. However it remains at all times the responsibility of the customer to ensure that Lameduck Enterprises materials are suitable for the particular purpose intended.
Insofar as materials not manufactured by or supplied by Lameduck Enterprises are used in conjunction with or instead of Lameduck Enterprises materials, the customer should ensure that he has received from the manufacturer or supplier all technical data and other information relating to such materials.
Lameduck Enterprises accepts no liability whatsoever (except as otherwise expressly provided by law) arising out of the use of information supplied. The application or adoption of the products described herein, the use of other materials in lieu of Lameduck Enterprises materials or the use of Lameduck Enterprises materials in conjunction with such other material.